WHy can't my character move?! -need help

[reasonbackkid]

WHy can't my character move?

There is no problem with the tilemap.

I just used some switches earlier and then transport the player into another map, then it WONT MOVE!
In that map, there are no switches, no parallel process, no autoruns. Just a plain map. When I put the player's starting position on that map, the player is moving normally.

I wonder if the switches I used earlier from the other map affects this?

for example I forgot to turn off some switches that is in autorun/ parallel process/.

Does the capacity of the game contents causes this Crash?


/Help  :down:

 

[Kain Nobel]

Screenshots and demos help...

Did you check every event (and event's page) to make sure that it's not set to autorun...? Do you have a "keystone" event that is supposed to set any special weather/fog/tint effects when you enter the map? Be sure to use an Erase event to kill it, or else you'll be stuck in an infinite loop (or, in other words, the game will 'freeze') especially if it's on Autorun and not Parallel Process and it hasn't been Erased.

Also, open the editor and double check the tileset passability and directional passability, even priority. There's too many things that could be wrong with it, I'm just naming a few. I know you said you don't have any autoruns or parallels, maybe its a switch having to do with a common event you were using for something.

 

[regi]

Is the tile the player's on passable? Check the layers above, make sure you don't have any impassable blank tiles. Remember to use the top-left tile only to erase.

 

[reasonbackkid]

Screenshots and demos help...

Did you check every event (and event's page) to make sure that it's not set to autorun...? Do you have a "keystone" event that is supposed to set any special weather/fog/tint effects when you enter the map? Be sure to use an Erase event to kill it, or else you'll be stuck in an infinite loop (or, in other words, the game will 'freeze') especially if it's on Autorun and not Parallel Process and it hasn't been Erased.

Also, open the editor and double check the tileset passability and directional passability, even priority. There's too many things that could be wrong with it, I'm just naming a few. I know you said you don't have any autoruns or parallels, maybe its a switch having to do with a common event you were using for something.

Thank you. KAIN nobel

I turn off ALL the switch I made (about 15 switches!) and It was not freezed anymore.

I have learned that I must turn off the switches.


TADA!

>Reasonbackkid  has level-up again in basic RMXP knowledge!<